Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,We did a one to one config migration from Cisco 6807 with Supervisor C6800-SUP6T to Cisco 9606R with Supervisor 2.After the migration we encountered traffic disruption within the network. Along with that we continuously received the log "PORT...
Hi,I want to change the current src-mac load balance method in to src-dst-mixed-ip-port or src-dst-ip method on a Cisco 9500-40X switch.I want to know,01.Without changing this on globally can't we change per port-channel?02.Specially want to know doe...
Hi,I am having a 6 switch stack and switch priorities as from top switch to last one are 15,14,13,12,11,10.I need to remove the last 4 switches from the stack and connect them to a existing two switch stack with switch priorities 15,14.I planned as b...
Hi, Here I have attached a snap for your reference.A and B are C9500X switches and C and D are C9300X switches. C and D are a switch stack. I need to know in case of stack broken between C and D what happen to STP ?This is a SDA environment and A an...
Hi all,Currently we are having Cisco 9300 Embedded Wireless LAN Controller as Fabric the fabric WLC in the SDA environment of the Catalyst Center.We are going to migrate this existing EWC WLC with C9800 WLC HA pair.I need your idea for the migration ...
@Joseph W. Doherty , as per the documentations Sup 2 not supported custom SDN templates for ACL scale. If im wrong please correct. Hence the only option is either go for object based acl and optimizing current acl set or have to go for sup1 which sup...
@Kasun Bandara after removing switch 3 if no provision command not executed on the stack then later day if added a brand new switch to stack will it take as switch number 3 or 4?
@LukaszC , if you are having a proper downtime, and if you have already config option 43 in DHCP pool, no need to add third WLC IP on APs. After you change the option 43 value for the New primary WLC all the APs will be connected to it. From the Catc...
@pieterh Does not the switch has a mechanism after the stack break even after some sort of time to change the bridge ID according to their own mac? or any command to to be added for happening it after a stack broken?
@LukaszC Existing APs were discovered the WLC by DHCP option 43. Once the EWC role removed from the Fabric Border those APs lost their connectivity to the WLC. After we added new C9800 WLC to the fabric site in one AP we changed primary base control...
