Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'd like to mark DSCP on every user port based on tcp and udp port ranges:1. mark udp range 16384 32767 to dscp 46/EF2. mark tcp range 2000 to 2002 and 2427 to 2428 to dscp 24Can qos acl support multiple entries?can I configure:set qos enableset qos ...
pls look at diagram attached. Router A and B are branch routers. B is PIM DR on the LAN becuase it has higher IP 10.36.200.3. There is only sparse-mode running and RP is WAN2 across the WAN links. 1. Normally, multicast tree is built from router B to...
pls look at diagram attached.Router A and B are branch routers. B is PIM DR on the LAN becuase it has higher IP 10.36.200.3. There is only sparse-mode and RP is WAN2 across the WAN links.1. Normally, multist tree is built from router B to WAN2(RP)2. ...
I am creating a self-study labs with a few 2600 routers. I plan to turn on multicast debug to observe those join/register/prune messages. I believe I can configure a router as "listener" by "ip igmp static-join" but is there any software (which I can...
thanks!We also have C6500 SUP32 running IOS without AutoQoS support. L2S19(config-if)#mls qos trust ? cos cos keyword dscp dscp keyword extend extend keyword ip-precedence ip-precedence keyword is it even possible t...
"router B doesn't put F1/0 in its OIList as this interface is also the incoming interface (rpf interface)"1. does it imply router B would "refuse" to build the multicast tree or not?2. in short, should this design work for multicast when link B goes ...
You can surely tftp remotely an IOS to router while older IOS is being erased. You just need to ensure new IOS is not corrupted in the process, or use ftp which runs on tcp
