Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a question about the cisco ACI license.We have 2 Pods, 2 Spines & 4 leafs for each pod, 2 APIC in pod 1, and 1 APIC in pod 2 and we need to renew ACI DCN license.My question is, why does cisco only count DCN licenses with leafs only and not...
Hi everyone,We have some issues with our ACI connection between 2 POD. The 2 EPGs between 2 BD on the same VRF that are located between 2 POD can't access each other. BDVLANxxx: EPGVLANxxx : POD1 : DCBDVLANyyy : EPGVLANyyy : POD2 : DRCWe are using ...
Hello, We have a problem here, this has been happening since 1 year ago. Client connections from the access point in our office are always drop randomly.We are using Cisco Catalyst 9800-L-F (IOS-XE 16.12.4a) and Cisco Aironet 1815i.The average device...
Hi All, I have some probleme with our connction.Early last week, our monitoring server in the inside zone could not reach the ASA device.The server also cannot ping the IP interface inside and vice versa. HW: ASA5585-SSP-10SW: v9.8(2)38 Topology: [Se...
Hi All, I just finished the initial setup for new ACI.Config the new OOB-Magement IP address for 3 APICsBut when open the "Node Management Addresses", the IP Address for APIC isn't there.However, when I open the APIC 1-3 configuration under the Syste...
Hi Chris, Thanks for the answer. By the way, the software we use is version 2.0(1n)What I understand from your answer is, to solve the Fault 0523 problem is to upgrade the ACI software to version 3.x? right? In "Out-of-Band EPG"Configuration Issues: ...
Hi stcorry, Thanks for the answer. But i have another questions, when i open Out-of-Band EPG - default under "Node Management EPGs"Configuration Issues: Not Associated WithManagement ZoneConfiguration State: failed-to-apply and the faults loggFault F...