Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,can any body tell me ,what is the modem type of NM-8AM modem module.i mean wt should i put in the following command as the modem type. modem autoconfigure type............should we use CISCO v110 or wt?regardssameer
hi,The problem tha i am facing is when i remove the access-list from the configration the PIX stop sending trafic out sided means internet stop working but the access-list that i want to remove has nothing to do with internet browsing as this is rela...
Hi,when i restart my pix firewall (failover unit ) its boots in the ROMMON mode which means there is a problem with the IOS but the problemis when i try to install the IOS on it which is 6.2(1) it gives me the following error message ...................
My existing pix (failover unit) has IOS of (5.3) veersion and i want to update it to 6.2(1) but when i try to copy tftp flash it shows !!!!!!!!!!!!!!!!!! these marks as its tranfering image but at the end the following message appears.Received 164613...
I want to download the pix image from my existing firewall to the newly bought failower firewall so that both of them would have the same IOS image and i can setup failover.
hi,i dont want to do do any thing with the MODEMCAP instead i just want to knowwhat should i put in the line configuration mode as a modem type.according to my knowledge there are two related commands 1)Modem autoconfigure discovery2)Modem autocinfig...
another trick there isa option in the 3000 client and that is Dial before login for on e of my my customer this setting helped me cause this is real authentication from the login domain .first u set up the ipsec tunnel and then u'll login, also try t...
hi,two weeks back i was searching for the same thing, when one of the cisco support personal told me that u should have to have a PKI infrastructure on ur network means the CA cerver, then i study the RFC for EAP-TLS and finally i am cleared about th...
hi,please check for the following requirements for the MIC, but i am unable to get the meaning of (TKIP ).Note: You must set up and enable WEP with full encryption before MIC takes effect. Note: To use MIC, the Use Aironet Extensions setting on...
hi,well my suggestion is to download the latest ACU from cisco site and configure it for LEAP cause i think its easy to configure the latest ACU and u'll able to understand the options.cause its the problem of client settings.
