Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi every one,i have this topology and it works good but i face issue with it.the topology is attached in below.the upper side running DMVPN with EIGRPASR-1,ASR-2-ASR-B are the hubsrouters (106,183,11) are the Spokesand the lower side running OSPF .R...
hi every oni have an issue with DMVPN Tunnel with IPsec.i will explain the design of the network as much i can.i have an ASR-1000 router (HUB), and i have more than 9 tunnel work on itevery tunnel has it's own underly network (Different Service Provi...
hi every one,i have an issue with EIGRP Relationship in DMVPN connections,the neighbor reset between the hub and the spokeand i got the Errors:%DUAL-5-NBRCHANGE: EIGRP-IPv4 77: Neighbor 172.19.1.36 (Tunnel191) is down: Interface PEER-TERMINATION rece...
hi everyone,i have to establish iBGP connection between the CSR towards the edge routers like (126,101,107,136,14,40)i have more than one service provider towards the edges and the BGP connections is normally established.the CSR reach to all Edge rou...
Hi every one,i have more than 250 site they are connected to an ASR 1000 Series cisco routeri tried to create dmvpn tunnel the ASR is the hub and the rest of 250 site are the spokes . (without encryption)the DMVPN is work fine and eigrp up on all si...
Hi,FTD-1 is receiving Routes form ASR-1,ASR-2 and ASR-B, i set ospf cost on FTD-1 to prefer ASR-1.as you say, once ISP-1 is down, ASR-1 EIGRP adjacency is down so ASR-1 should no longer have any EIGRP routes in RIB, thus no longer redistribute EIGRP ...
thanks for replyingthe problem is on the FTD-1 i prefer the path to ASR-1, and because ISP-1 SW is Shutdown ASR-1 cannot learned eigrp router from spokes so 172.29.29.21(9K) Cannot reach 10.11.0.0/16 (Spoke)i fixed it by matching routes on FTD-1 com...
thanks for replying.when i remove the tunnel BW (10) The EIGRP neighbors become stable.my question is why the BW effect on eigrp neighbor relationship ,what i know about the values (BW ,MTU,Load,Delay and Reli)effect of path selection of eigrp multi-...
