Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I read through data sheet that 1921 and 1941 supports with concurrent speed enabled up to 15 MB and 25MB respectively.What does that means?Does that means I can't use WAN speed of more than that on one interface or overall wan speed? I do have two...
Hi,We are using a ASA 5512.Inside there are not more than 20 odd hosts. This is lying at remote office and is managed remotely via ssh if required.We are using 9.1(3) firmware. Around 4 months backthere was one incedent internet stopped working afte...
Hi,I am using 3560.IP rouitng is being turned off on this.Curious to know if I will create etherchannel or port channel.I think etherchannel.Correct me if I am wrong.On connecting switches I have vlan10,20,30 to be allowed.I am sure I need to allow t...
I got the charge of a ASA 5510 running with 8.3(1) version.Found that this is simple config with Patting for inside host and couple of Static Nat for web servers and FTP server as well.There is lots of other configuration being done,I assume for the ...
Hi,Running ASA 5510 with code 8.3 in it.We have our few https portal and OWA websites in HO.We access these sites from the network behind the ASA.All works perfectly fine.In order to have control on internal network traffic we placed a web-filtering ...
The problem started only when fortigate introduced in transparent mode to filter the websites.Though we have checked it by allowing all the websites by allow rule.But these sites doesn't work.Removing the fortigate from the network allows the website...
Thanks Peter.Router on stick is quite understandable.Thanks for that.I wanted to understand why to have router on stick configuration?If we go plane configuration,with ip on physical interface of router and connect to trunk port of switch.Now on swi...
Hi,Any inputs on this?What Toshi has shared is router on stick configuration.That will allow intervlan routing?Do we really need to do routing among Vlans?Would like to know can't we create vlans on 2960 itself ?Add all ports except one (for trunkin...
Thanks to you guys for your inputs.I been told by HO that they are looking for setup of VOIP to start with of.Something like same will be setup end of the year at HO.As of now the PRI will process the calls.But instead of EPABX,2921 router will act ...
