Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I has gone through all other thread that showing major alarm, it said that deleted the files in local1/core_dir or local1/crash will remove the alarm, but i just did the same thing, still the alarm show as below:WAE#sh alarmsCritical Alarms:---------...
I have a SFP-10G-LR module that running fine 3750x switch, but one day without any symptom the SFP not running, from the log it was show link down that is all, no power failure also. So what possible that will cause the module failure?
Can we still monitor the traffic and control the subscriber even we do not have any Collection manager and Subscriber Manager? with SCE alone couldn't analysis or control the traffic?
Need help after i factory default with below method, then the ip phone show "Unprovisioned", then "File not found SCCP48" then reboot by itself. Running on SCCP, CUCM 7.0. Only this phone having problem while to register, all other phone running fine...
We have around 50 remotes switches which are connected via a lease line, only 3 switches are not able to telnet, while try to telnet:The switch will stop responding to the monitoring system, ping will request timeout (before telnet to the switch, tha...
the interface status show down down, not connected. And i can sure it is inserted properly, i have remove and insert for several time but still the same result, even i plugged it to other port, still the same. I even run show inventory after i insert...
yes, the the phone is defined in CUCM, when i search SEP+MAC i can see the phone is unregister. The phone is using default settings. What if i don't want to get the phone upgrade firmware but remain the default version on my CUCM? Since that page say...
but in my case there is no "Auth Fail" error message, and i have this issue is because of the phone keep getting wrong DN which is not exist in the CM, then i factory default it, i am not getting this problem from upgrade firmware. So above method st...
