Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey everyone. I'm currently testing LMS 4.2 and I setup a new install. I was able to discover devices, check and backup configs and check for compliance. One thing I can't do is setup pollers to monitor performance. If I click on setup (or any of the...
Here's what I see when I do a show ver in console:Hardware: ASA5505, 210 MB RAM, CPU Geode 500 MHzInternal ATA Compact Flash, 128MBBIOS Flash M50FW080 @ 0xffe00000, 1024KBThat 210MB doesn't seem right to me... Anyone ever see that before?thanks,Chr...
Hi guys. I'm having a bit of a problem with configuring IPSEC VPN on an ASA 5510 and using ACS to send ACLs to restrict traffic. Here's the problem: Clients from a specific group in ACS attempt to connect to the ASA using the Cisco IPSEC VPN client b...
Hi everyone. I read that SSL load balancing is not supported on the ASA. I was wondering if that's really the case and if so, is there a way to just "pool" my two ASA with 250 SSL each to make it 500 total in a cluster?I'm not really looking for fail...
Does the license limit of 10 inside hosts apply only to hosts to go out to the internet or will it apply also to hosts that go through a lan to lan tunnel I created? I will have about 20-25 PCs on a lan behind a ASA that's gonna be linked to our main...
Thanks, Victor, I will check to make sure there aren't any problems with the key. I did some tests and it seems I can set a key for an interface even though authentication is not set in the area. This simplifies my task since I'll just apply the comm...
Thanks for your reply, Istvan, although it's a bit of a letdown since I have lots of interface to configure On our main switch I have 3 processes with about 30 interfaces. Is it possible to enter the "Ip ospf message-key 1 md5 password on an interf...
