Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
1. What is the significance of the LACP Neighbor "Dev ID" ? It looks like it is a combination of priority.macaddress.I am seeing some inconsistencies in the output of some show commands on a Cisco CBS3110G (Cisco-IBM Blade switch) runnning IOS ve...
We are building an IBM Blade server environment. We basically have (2) IBM chassis's. Each chassis has a 3110 in bay 1, and bay 2.We are using the VBS feature on the 3110's to virtualize the switches.My questions is on the uplink's from the 3110's to...
When configuring a zone on FM it looks like you have an option to zone by "wwn" or by "device-alias". I am trying to find out the pro's and con's of zoning by each option and which option is better. John R.
I am testing the failover process (Active / Standby) on the FWSM modules.Setup: (2) cat6506's (2) FWSM modules configuredSwitch#1 - hosts primary FWSMSwitch#2 - hosts secondary FWSMSwitch#3 - Internet/Gateway routerI have the FWSM configured to...
I am having an issue with a DSL link running PPPOE over Ethernet and NAT on a 1720 router. The 1720 router has (1) T! interface and (2) Ethenret interfaces. My internal clients use a spoofed IP address. When they go to the internet they go through a ...
Thanks for the suggestion.I checked and the switches were using PVST. I changed them to use Rapid-PVST. I ran the tests again with the same results. I think it has more to do with the failover process. When the primary FWSM loses contact with its mat...
Thanks for the reply. I already have the failover critieria parameters set to the minimum.unit fail: 1 secondunit hold: 3 seconds (must be 3 times unit fail)Monitor interface: 1 secondThe issue that I have is that if the link from switch#1 to Switch#...
