Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,In a 5508 WLC HA scenario with one WLC having a valid AP Count license and the other WLC having a HA SKU, in case the primary wlc failed for an exceptional long period of time, is there any limitations during the time when only the secondary wl...
Hello,In case I have to implement a wireless network with 15 Catalyst 9124 access points using the Embedded Wireless Controller solution, do I need to use the EWC AP image for all the 15 APs or just for those serving the primary and backup EWC role?T...
Hi,
The 5508 wlc service port is configured to use dhcp instead of static ip address, however, when I connect a notebook with dhcp server software to the service port, it cannot obtain an ip address from the dhcp server.
I tried 'OpenDHCP' and the ...
I have a case in which due to environment constraints, if mounting the IW3702-2E vertically with 2 omni directional antennas pointing upwards and 2 pointing downwards, there would not have enough clearance such that the upper 2 antennas would be bloc...
Hi,
From the “Cisco Industrial Ethernet 4000, 4010 and 5000 Switch Software Configuration Guide”, “Chapter: How to Configure EtherChannels”,
https://www.cisco.com/c/en/us/td/docs/switches/lan/cisco_ie4010/software/release/15-2_4_EC/configuration/gu...
Thanks Marce & Scott,Understood that in such scenario, the failed primary controller should be replaced asap. Just want to know the risk before it is replaced and only the secondary controller is in place.Am I right to say that:1. there is no differe...
Thanks Rasiak,
Looks like configuring static ip address to the service port when required is the current option.
I also found that the 'Standby Hot' unit do not have the 'set' command while the one in 'Active' or 'Maintenance' mode have.
