Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello colleagues!I have a problem for which I have not found a solution. There is a network with several hubs connecteb by VPN (Mesh).Traffic from hosts in network of one of this hubs to the internet goes directly through the local ISP (split tunnel)...
Hello colleagues! Tell me what is the maximum number of active vlan on switches Catalyst 9200, 9300 and 9500? Where can I find this information Didn't find it in data sheets. Best regards,Sergey Popov.
Hello! Does anyone have table with explanation of ethernet ports led colorors and state codes for catalyst 9500-40X?I have installation with two Catalyst 9500-40X and most of active ports blinking green, but several of active ports blinking green and...
Hello!
The recomendations for vpc peer-keepalive link said thats for dedicated link 1 Gigabit is sufficient.
If we need to use L2 switch to connect nexuses peer-keepalive link, and we have only FastEthernet ports in that switch, is it will be enoug...
Thanks a lot!I couldn`t find this soluthion, beacuse my devices do not have this feathure. This feathure require MX version 15.4 or higher. My devices now running with MX 14.53.Yes, i can assign a clients to separate vlan. I will upgrade my devices a...
Sorry, but no. It couldn`t apply. 9500-40x have SFP+ ports, not copper. There is no PoE.And in our project thats switches are the core. All ports to access switch bundled by etherchannel and they are root in STP. All pord are in Desg state.In Etherch...
Hi! Of cource i saw installation guide, but it doesn`t contains information about ethernet ports LED.Table 10 contain information about system LED, not about port LED.
