Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone! Imagine there are 2 routers configured with HSRP with IP addresses R-01 (active) 10.0.0.1, R-02 (standby) 10.0.0.2 and VIP 10.0.0.5. A third router R-03 (10.0.0.3) estabilishes BGP neighborship with the virtual IP address (10.0.0.5) and...
Hi everyone! I noticed that there are 2 fields of IP address information when configuring static IP Address on APs at the WLC 9800 GUI at page Configuration > Wireless > Access Points >All Access Points - General. One field is "Static IPv4 Address"...
Hi everyone, I'm trying to understand the logging messages of an Cisco AP C9115AXI, but it is very difficult to interpret. Is there any documentation explaining the meaning of each message? Thank you!
Hi everyone!In a project, part of a company's network will use Meraki and another part will not. Communication that is initiated from any company LAN network (Meraki or not) must be allowed to enter into Meraki LAN. The sites that will deploy Meraki ...
@BRUCE NEWTON Thank you for your answer!There is SD-WAN and Auto VPN between the Meraki MX Spoke and MX Hub.The LAN port of the Hub MX is connected to a Layer 3 switch Core (Let's say I configured a single LAN with network address 10.0.0.0 /24. So t...
