Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a problem with a 2801 router running both static NAT (inside-outside), a basic dynamic NAT (outside-inside) and two dynamic NATs through two route-maps (inside-outside)...The Static and basic dynamic NATs work OK so no problem there, but the p...
Hello, I have been posed a question by a SAP application team - they wish to load balance from a SAP application server, targeting URLs.The SAP server will target URLs, resolving to the CSS - the CSS must then load balance these requests across other...
I have a 3030 on 4.7.2 software with a VPN configured to a PIX506e on 6.3.5 software.Isakmp/IPSEC Phase 1 and Phase 2 come up when traffic is started from Concentrator end, but the Concentrator will not send traffic to the remote end in the IPSEC tun...
I have a 3550 running an enhanced software image (c3550-i5q3l2-mz.121-8.EA1c) and i am having difficulty configuring a route-map. The route-map configures ok in Global config, but i cannot apply the "ip policy" command to either a non switched interf...
I cannot use the "ip nat inside source list" command as this will not create fully extended entries in the NAT translation table. It must be through a route-map as the same end-users will be using both NAT pools that are run through route-maps.
Vikas,Local network: - 10.1.0.0/0.0.255.255Remote network: - 10.108.1.0/0.0.0.255I have no filter applied to the tunnel under configuration||Tunneling & Security|IPSEC|LAN to LANMark.
Vikas, There is only a single tunnel on the Concentrator Pix config is shown below: - logging buffered debuggingicmp permit 10.108.1.0 255.255.255.0 insidemtu outside 1500mtu inside 1500ip address outside 81.137.x.x 255.255.255.248ip address inside 1...
