Hi I am tring to understand the operation of multi layer switching. i am confused. according to the book its mentioned that traffic between the subnets is routed by a switch. the part that confuses me is why would some one connect 2 diffrent subnets ...
HiI am trying to configure VLANs on my switch. I configure 1 IP addresses to each VLAN interface. for some reason I cannot ping the VLAN2 IP I can only ping VLAN 1.Both the VLANs have same MAC address, so i tires to change the MAC but it says that th...
Hi I am preparing for CCNP, I ahve a question about AS is ospf. What determines if a particular router belongs to an AS, is its the OSPF process ID? I am not clear about thisthanks
HiIf I have 2 routers connected back to back with a cross cable, is there any way i can control the bandwidth of the channel between the router. actually i need to control the bandwidth to set up a test enviourment. any solutions ?thanks
Hi Thank you for sending you commentsOne thing i am not clear with is, say I have to connect my AS with another AS and both run ospf. how is this handled.
