Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone tell me if Cisco have resolved the issue with the VPN client integrated FW and Windows Vista. I have downloaded the beta version 5.0.0.90, but this doesnt work if I set my VPN policy requiring that the client use the IFW.I have clients co...
I'm proposing to install two pix firewall in a lan based failover configuration. Each firewall will be physically installed at either end of a DWDM link. I'm dedicating interfaces and vlan's for both the 'failover' and 'stateful' connections on eac...
I'm picking up the following message on one of my VPN routers.Oct 9 11:31:58.680: %DUAL-5-NBRCHANGE: IP-EIGRP(0) 1: Neighbor 172.31.99.5 (Tunnel1) is down: Interface Goodbye receivedI don't understand why EIGRP is clearing the neighbor relations of ...
I have a 2600XM router acting as an OSPF DR. This holds 147 routes. 46 are Intra area routes and 101 are External type-1. The router is running IOS ver 12.2(8)T5 with 32mb DRAM. This peers with 8 neighbours. Everytime I add static routes on a firewal...
Hi Marc,If you are setting up a site-to-site (lan-to-lan) tunnel, then it's worth checking you have all the routes necessary in place.I had a similar problem where phase 1 was not completing. This turned out to be a missed route on my cisco router r...
Thank you very much!The problem was indeed with the acl at the VPN3000 end. After configuring seperate acl's for each tunnel this seemed to work.Many Thanks again.Neil
I have changed the distance for external routes being redistributed into the backbone area on the PIX. This seems to have done the trick. I have monitored the routing tables this morning, and all looks ok.Many thanks for your help Russ.CheersNeil
