Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Recently I've found post about standby APIC in Multipod topology. Technology is based on using the same Node ID (2 for example) for fourth APIC at second pod, and keeping this node powered down and separated from fabric. Then during disaster recovery...
Tunnel established between Cat6509 with VPNSM and 7206VXR with VAM2+ and tunnel protection by IPSEC is used.When I send traffic in one session between Windows 2000 servers (located on 6509 and 7206 sites respectively) by this tunnel, I have 110 M...
Hello everyone. I have IPSEC between two sites, and unicast OSPF (with neighbors). IPSEC works on VRF interfaces. Problem is - all traffic between sites encrypted, but not OSPF :-(. How can I fix this? Or OSPF over IPSEC isn't supported by VRF?3825-1...
According to release notes your switch is supported
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/release/notes/aci_nxos_rn_1223.html
Try to check software version which your switch is running now, maybe it is newer than...
Perform a firmware upgrade on spine switches without an apic
https://supportforums.cisco.com/t5/data-center-documents/totd-how-do-you-perform-a-firmware-upgrade-on-spine-switches/ta-p/3162792
I've done it recently on 9336PQ. USB flash should be forma...
After experimenting in the field I can confirm that "warm" standby works in Multipod topology.Topology was: Pod1 - apic1 and apic2, Pod2 - apic3 and apic21 (standby).We've done two tests - first was replacing "alive" controller apic2 from Pod1 by sta...
Gabriel, thanks for reply.
As I can see from provided whitepaper there is following text (below figure 23), I meant it in my first post.
The specific procedure required to bring up the standby node and have it joining the cluster is identical to ...
