Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've got an old 2503 router I want to use to connect to a T1 connection for a temporary solution. I just want to confirm that the serial interfaces on this router can support a full T1. Thanks.
Since I have upgraded to v7.0 on my PIX525 I have noticed a weird problem that I have been unable to resolve with regards to my PIX syslogging. A handful of times per week, I get log messages that indicate my email gateway is trying to send approxima...
Hello, I want to use a Cisco 3005 concentrator as an SSL termination point for client transactions over the Internet. Essentially there is a custom app in client offices that we want to communicate with our back end servers over the Internet. We want...
Is there a way to have multiple IP's on the Outside interface NAT to the same IP in my DMZ.For example, I have a web server at 172.16.1.9(DMZ) and I want to have all connections to 10.10.10.1, 10.10.10.2 and 10.10.10.3(Outside IP's) natted to the 172...
I have installed a WIC-1DSU-56K card into a Cisco 1721 router and the card came with a CAB-DSU-RJ45 cable. My telco tells me I require a RJ48S or RJ48C cable to connect to the Frame circuit. I read on a vendor site that the CAB-DSU-RJ45 is equivalent...
Multiple HTTP sites on the same server, but this is only a temp measure while performing maintenance on one of our web servers and we were trying to avoid having to involve our ISP who host our DNS for us. I didn't think I could do it but wanted to c...
