Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have 5508 WLC on the latest firmware and two AP1562D acting as a bridge(mesh). The bridge works well but consistently, every 16-17 minutes it goes down for about a minute. No power issues. No interference on the channel. No obstacles. 300 fee...
Hello,A bit perplexed here. Replaced 10 switches with new switches connected C4500 via fiber. All switches run MST0. C4500 ports always link up and have no errors. But all 10 C4500 fiber downlinks follow this cycle: about 30 seconds in "forwardin...
Hello, I'm setting up a lab and encountered the following issue: after adding vbond and successfully applying a certificate and template to it I tried to do the same with vSmart. But vSmart does not accept the cert because it does not have a correct ...
Hello, I'm building a lab and just want to have vManage/vBond/vSmart connected at this point. I added vBond to Controllers list and applied a template to it. It sits with "Sync Pending - Device is offline" Status. But the devices are obviously commun...
Thank you for sharing. Sounds like fixing this problem is not worth the effort. We'll just replace Cisco with another vendor WAPs for this bridge. It'll be quicker.
There are similar log events right before re-establishment of the bridge link. Are you sure thest HT VHT logs entries indicating some issue ?Jul 7 15:01:55 kernel: [*07/07/2023 15:01:55.2962] INFO-MeshRadioBackhaul[1]: Tx ADJ Response to 3C:51:0E:F9:...
Hi Flavio,No flaps, no errors. STP looked fine but just in case I disabled STP from both sides of the bridge. It did not affect anything including the bridge drops.
I've just disabled Bridge Assurance and still observe the same problem. No "inconsistent" ports found in cli output or event log.Counters errors - 0 for all interfacesCORE2#remote command ^% Invalid input detected at '^' marke...
Here it is. As I mention in the other reply at this point I do not believe the STP is the cause but rather a consequence of some port drop/flap. CORE2#show spanning-tree summarySwitch is in mst mode (IEEE Standard)Root bridge for: noneExtended system...
