Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Once again I have experienced a surge of Energy Detect Defers that have degraded access to my Cisco 1220. I have asked this question here before but never gotten any information on how to identify and resolve this issue. Can anyone please help?
I have a 350 with the latest IOS release installed. Occasionally the AP locks up. I cannot access the internal web configuration, ssh, telnet, or ping, but snmp appears to continue to function for some time. The radio is on a tower, so I can't access...
I am novice in the router world, so any help would be greatly appreciated. I have a Soho 97 router and I would like to set it up so that some machines on the LAN can have public IP addresses but most others would have private IP numbers that are hand...
Could anyone give me their thoughts on why I would see bursts of Energy Detect Defers occasionally? I will usually have about 20-40 per 5 second interval on my Cisco 1200 with IOS but I will have everyone drop off of the AP for 5-10 min. and during t...
Doesn't release 12.2(15)JA resolve that?I have 12.2(15)JA and have the same outgoing Dot11 errors on occasion. My radios will unexpectedly lock-up or reboot themselves unexpectedly too. Meanwhile, my VxWorks radios keep humming along. It's a real bum...
I wouldn't expect it to work with so many, but I noticed when experimenting with SNMP that there are 256 registers for storing associated MAC addresses. I have two 350 APs with 25+ clients on each running IOS and the processor usage, memory and traff...
My web interface is different (maybe you were doing it from memory?);1- Select 'Network Interfaces' from the menu2- Select 'Radio0-802.11B' (your's may differ here)3- Select the 'Settings' tab4- Scroll down to 'Public Secure Packet Forwarding'5- Sele...
I have the same situation. Has there been anything that you have done since then to fix it? I am running about 25 clients off of it with light loads. It is upgraded to the latest IOS (15).
I had a similar thing happen after upgrading to IOS from VXWorks. I was able to use the link below to get things working again:http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a00801f074a.shtml
