About darren.frowen

darren.frowen · 04-23-2005

Hi,If anyone could help or advise me on the following problem. We use Cisco7206VXR for our voice gateway with PA-VXC-2TE1. A customer is arrempting to originate calls over IP via a Qiuintum DXC2030. Rhe problem is that the calls is abruptly terminate...

darren.frowen · 09-09-2004

Hi,I have recently implemented a dial plan consisting of around 60 pots outbound dial-peers. My problem is that if using an IP phone the call is never matched against the logest prefix match. It always drops into the less specific match of '.' period...

darren.frowen · 07-23-2004

Hi,I am getting the folowing error when debugging on isdn Q931 on a cisco7500 with a PA-VXC-2TE1 connected to a Ascom PBX:**ERROR**: CCPRI_Go: call id 0x26 event 0x57 No ccb Source->HOSTBasically the problem is that call set-up appears to be fine, ho...

darren.frowen · 04-26-2005

Hi GS,Thankyou for your time and update. Then Called and calling numbers are as follows:Called: 00441788523003Calling: 12345676Please see attached "show run" and Network diagram.Your help in this matter would be gratley appreciated.Kindest RegardsDar...

darren.frowen · 04-23-2005

Hi,Are you using a voice class codec to negotiate the codec other than the G.729?RegardsDarren

darren.frowen · 04-23-2005

Hi,Its sounds like to me that you require the IPIPgw software, which is not available for the 7206, The Cisco Multiservice IP-to-IP Gateway is a special IOS software load that runs on the Cisco 2600XM, 3660, 3725 and 3745 series of multiservice gatew...

darren.frowen · 09-15-2004

Murabi Hi,You miss the point. Im using longer prefix matching on 60 other dil-peers and the particular device never matches on any of them only the default!RegardsDarren

darren.frowen · 08-14-2004

Jasyoung Hi,You are an absolute genious, it works a gem:Aug 14 20:14:38 bst: ISDN Se4/0/0:15 Q931: RX <- SETUP pd = 8 callref = 0x0024 Bearer Capability i = 0x8090A3 Standard = CCITT Transer Capability = Speec...

Member Since	‎03-30-2004 08:28 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	14

User Statistics

User Activity

Calls disconnect after error %CALL_CONTROL-6-NUMBERING_TYPE_NO_MATCH

The logest match is never made on pots dial-peer!!

Call disconnects after 4 Seconds every time HELP!!

Re: Calls disconnect after error %CALL_CONTROL-6-NUMBERING_TYPE_

Re: Cisco 7200

Re: Call routing

Re: The logest match is never made on pots dial-peer!!

Re: Call disconnects after 4 Seconds every time HELP!!