Calls disconnect after error %CALL_CONTROL-6-NUMBERING_TYPE_NO_MATCH

[darren.frowen]

Hi,

If anyone could help or advise me on the following problem.

We use Cisco7206VXR for our voice gateway with PA-VXC-2TE1.

A customer is arrempting to originate calls over IP via a Qiuintum DXC2030. Rhe problem is that the calls is abruptly terminated without being able to establish the Telphony call leg.

I turn on "debug voice ccapi inout" and the following error is seen:

Error Message

%CALL_CONTROL-6-NUMBERING_TYPE_NO_MATCH

Cisco.com says reference this error:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123sup/123sems/123semv1/emgc6msf.htm#1034779

Error Message

%CALL_CONTROL-6-NUMBERING_TYPE_NO_MATCH : The called number numbering type did not matchThe event for the callid [dec] is being discarded.\n

Explanation: The event points to a session application that no longer exists. The event is being discarded.

Recommended Action: This message is informational. No action is required.

Can someone please help me to know why this is happening and how I may overcome this!

Anyone help would be greatly appreciated!

Kindest Regards

Darren Frowen

Senior Network Engineer

Satellite Media Services.

[sriram.g]

Hi,

Can you paste the necessary config, calling and called number and a small ASCII diagram.

Thanks

GS

[darren.frowen]

Hi GS,

Thankyou for your time and update. Then Called and calling numbers are as follows:

Called: 00441788523003

Calling: 12345676

Please see attached "show run" and Network diagram.

Your help in this matter would be gratley appreciated.

Kindest Regards

Darren Frowen