I have PIX 506E with version 6.3(1). I'm creating virtual interface on this but getting following error:**********************************[ERR]interface ethernet1 vlan13 logical Interface limit (2) reached.Unable to create logical interface.Internal ...

Hi Gurus,I have Cisco pix 515E (HA) firewall on production setup. Initially setup was done for less number of private hosts, so setup is like:Inside Interface IP is 10.10.8.0/255.255.255.0 .. Here I can use only 255 hostsMy question is Can I add one ...

I have Internet pipe from data center poeple. This pipe is directly going to cisco 2950 24 port switch(in public VLAN). I have another same switch trunk with primary switch.now in my production setup switch1 is the single point of Failure. Some body ...

I'v allowd one private IP address to sepcific machine on tunnal ACL. My problem is when ever there is no acitivity from client side -- pix will block the traffic.To enable the traffic I need ping client IP from specefic machine.Any idea what's wrong

Hi,Let me explain my Networks:I have HA cisco pix 515E with Public outside interface and private inside interface. One interface I'm using for state failover.My local lan in 10.10.8 series.Now I have to connect the one more extra lan(from dirrent dep...