Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm currently deploying a VOIP from a branch office with an existing VOIP at the HQ, I could place a call from own end BO clear, but could not receive from the HQ, I changed from an FXO to an FXS but still the same problem.I wonder if someone could m...
Drea all,I'm a young engineer with less than 6 month experinace.My boss is on my neck to configure a complete security for a bank with a number of remote sites, on some sites they have Cisco 831,on some 2600,some 1750, some 1760,and the main office 3...
Hi guys,I have being cofiguring an AS5350 for voip for 2 ends. At my end the connection is C7 SS7 signalling from the switch to the router.The router and the switch is not seeing each other.The following are my configuration on the E1 controller E1 3...
Hello, I have been configuring AS 5350 for Voip from my site to another. The AS 5350 is connected to a traditional Switch sending dial digits using R2 Signaling. The configuration of my controller e1 -/- is as follows: Controller e1 -/- framing NO-CR...
Hello, I have been configuring AS 5350 for Voip from my site to another. The AS 5350 is connected to a traditional Switch sending dial digits using R2 Signaling. The configuration of my controller e1 -/- is as follows: Controller e1 -/- framing NO-CR...
