Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've just obtained CEM 5.0 and installed in a test environment. I have a few questions1. Does the RootRule run all the time,and if i make my own rules, do i have to add them to the RootRule under a true or false leg?2. Microsoft Java Virtual Machine...
I have a network with the following config. Site A and site B connected via VPN tunnels thru pix. Access-list says don't nat site A to site B and permit site A to site B thu the vpn tunnel. (and vice versa) Off site A there is a stub network (sit...
I have several VPN connections in my organization.At one site the PIX VPN was configured by a consultant who created the access-list with a summarized route to my network.In my configuration, i did not route summarize, instead i allowed access from t...
I recently upgraded my LAN to a Catalyst 6500 with gigabit fiber to 3500xl switches. Now whenever anyone copies a large file 50MB+ to or from a server, the LAN "crashes". Some or all workstations have packet loss, or complete disconnects from apps,...
I have two LAN's with a VPN tunnel between the two. The tunnel is created on PIX 525 firewalls. The firewalls each have a DMZ. I have several servers in the DMZ's. Is there a way to allow site A to the DMZ on site B through the tunnel?
no errors, infact, the NIC's on the server and connected ports were set to 100/full at the start of the project.The entire LAN is made up of Cisco Equipment (routers, switches, etc) so there are no mismatch problems. The only time we experience any...
Hi, yes that configuration is already in place. And the routing is setup. We use the Tunnel for inside network to inside network communications. My question is, though, I cannot get to their DMZ.There are routes from my LAN (lan A) to the other LAN...
