About mnewman

mnewman · 04-29-2005

How would I configure 2 active tunnels to a 3030 for one site? I want both tunnels up at the sametime. I have2 3030's in a VRRP configuration,Thanks

mnewman · 09-23-2004

Hi,As I understand the signal strength of the AP's rabbit ears work in a figure 8 pattern emanating outward from the AP itself. If I use the longer range omni-directional antennae 2400MHZ (manufactured by Cushcraft) I believe the signal strength then...

mnewman · 09-23-2004

Thanks

mnewman · 06-22-2004

Jon,thanks,Mike

mnewman · 06-14-2004

Hi Jon,What did you do? I still have no solution.Thanks,Michael

mnewman · 06-09-2004

Lee,can you share your config minus any revelant ip's etc. I am also working on configuring the 1 port adsl wic for my 1751 to sbc (want to eliminate the cayman). I used a config that I thought would work but can not pass IP traffic. SBC confirmed th...

mnewman · 06-09-2004

I am having the same issue with a 1751. The 1 port adsl card. I was able to confirm an ATM ping with SBC but I could not route out. I am using a VLAN interface rather than a BVI. But the rest is the same. FastE is nat outside Vlan is nat insideI'll c...

Member Since	‎05-04-2004 09:48 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	7

User Statistics

User Activity

2811 2 egress points to 3030

Omni-Directional Antennae Coverage

Re: Omni-Directional Antennae Coverage

Re: 1721 Config for SBC DSL - Round 1

Re: 1721 Config for SBC DSL - Round 1

Re: What is "%IP-4-ZERO-ADDR:" message mean

Re: 1721 Config for SBC DSL - Round 1