Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone, this is weird.I have a 4006, with a sup III, 3x 400W power supplies and yet when I do "show power" inline power shows available 0 and none of my phones turn up.I've tried to configure power to auto, switchport to 802.1P, setup VLANs a...
Hello,I have quite a few tunnels already setup (L2L) but now when I try to add more and I enter all the crypto and isakmp settings (including peers, interesting traffic etc) the Pix takes the commands, it does not say that it's incomplete but then wh...
Hello,I have 2 P2P DS-3's and they are setup with CEF per-packet, I also have a few T-1's as a backup (MLPP), however I only get 30 MB transfer (peak) from the two DS-3's, looking at traffic they ARE load balancing but I never get the full bandwidth...
Hello everyone, I'm probably a little off, tired, working on too many things and I need a fresh pair of eyes...The VPN tunnel in the config below establishes but I think my access lists are messed up.The vendor see's my INTERNAL IP range instead of t...
Hi Layout1:companyA-VPN PEER-- Internet -- PIX1--Router1-Network1All users from network1 are able to connect to companya through the VPN tunnel, however I have several other office inside that I need to go through the tunnel.Layout2: ...
Would I be able to power all phones plugged in to a WS-4248V-RJ45 using the setup below?I want to fully populate the chassisChassis Type : WS-C4006Power consumed by backplane : 0 WattsMod Ports Card Type Model ...
You are right, it's a WS-X4148V-RJ45 but I also have a WS-X4248.I thought one of them would power up using the power supplies in the chassis, according to the docs I've read so far.I have already ordered th PEM and external chassis so i can test earl...
For anyone else that is interested - I removed the MLPP from the T-1's (bundle) and added the DS3's to the bundle instead, only one bundle per peer it would seem.
Thanks Rick, but when I tried it on the DS-3's MLPP never comes up, looking at debugs it shows that:Jul 25 23:38:16.834: Sey/y MLP: Request add link to bundleJul 25 23:38:16.834: Sey/y MLP: Adding link to bundleJul 25 23:38:16.834: Sey/y MLP: Bundle ...
Hi there.I am actually doing the Exact same thing on a different pix, i.e PAT and it's working just fine.HOWEVER, the difference being that the PAT address on the working PIX is a private, vendor specified IP and this is a public IP....Anyone????
