About pineapplebob

pineapplebob · 01-25-2005

Situation:Three internal hosts (192.168.1.104,105,122) can route perfectly for web browsing, telnet, ping etc. All other hosts cannot browse, route, ping, or telnet beyond WAN router. All other hosts can ping inside LAN router, outside LAN router, in...

pineapplebob · 11-12-2004

I have two 2501s each with IOS 12.2 and 16MB. They are linked with a DTE/DCE serail cable. One is linked to our T-1 and the other to our LAN. When going through the routers to the net, I get about 60k throughput. If I bypass the Ciscos, I get about 8...

pineapplebob · 05-10-2004

I have recently inherited a FastHub 316T model number WS-C316T with 16 ports onboard and the additional 16 port 100Base/TX board installed. This device works fine, however I am sure it is not running at full-duplex. File transfers accross the LAN are...

pineapplebob · 01-26-2005

Yes, they are as follows:A couple notes first, the x.x.x.65 is our ISP routerthe x.x.x.66 & x.x.x.78 are our DNS and our address range is x.x.x.65 - x.x.x.78 and we are using, obviously, 192.168.1.x/24 for our internal addressing scheme.First the LAN...

pineapplebob · 11-15-2004

Ramzi!Thank you. That was it. I reset the clockrate to 1000000 and it flies at 886k typical. I did not set to full 1500000 as I do not require full `bandwidth' throughput from the T.Again, thanks that really helped me.Bob

pineapplebob · 05-11-2004

Yep, I totally slipped gears on that one. Thanks for reminding me. Right on target.Thank youBob

Member Since	‎05-10-2004 07:12 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	6

User Statistics

User Activity

LAN to WAN, NAT, route issues from LAN hosts

(2) 2501s T-1 slow

Full Duplex on FastHub 316T possible?

Re: LAN to WAN, NAT, route issues from LAN hosts

Re: (2) 2501s T-1 slow

Re: Full Duplex on FastHub 316T possible?