I have a couple consultants that need to establish a terminal session to a few of our servers. I am currently using a 1760 router for internet connectivity. What would be the best/most secure way to allow the consultants access?ThanksRob
I created a user account on my 1760 with a privilege level of 0. However, with this user account I can still telnet into the router and make config changes. What am I doing wrong?ThanksRob
I created a user account on my 1760 with a privilege level of 0. However, with this user account I can still telnet into the router and make config changes. What am I doing wrong?ThanksRob
I am trying to dialup to my 1760. I have a WIC-1AM installed in it. While configuring line, I keep getting the message "%Autoselect during-login disabled on line 1, until 'login' is set" What does that mean?Thanks,Rob
Thanks for your response Rick. I since have got it working. I just had to setup an "enable" password. Users can dialup to the router (local authentication), establish a PPP connection and access network resources. If the users establish a telnet ...
Thanks for your response ritter.Can I connect these two connections to one router for a level of fault tolerence? What IOS command would I use to initiate this? FYI the router I am using is a 1720.Thanks againRN