Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've started looking into the newly-introduced IOS feature that allows Reliable SYSLOG Delivery over BEEP (RFC3195). It looks intriguing and I want to test it out.I'm a long-time, very happy user of syslog-ng on Linux. It looks like the syslog-ng d...
I'm having some trouble with dynamic spoke-to-spoke tunnels in my DMVPN topology. Essentially, each spoke uses a T1 at Serial0/0/0 for the primary DMVPN network and a T1 at Serial0/1/0 for the primary Internet circuit. Static routes with varying ad...
I've discovered the feature 'Using 31-Bit Prefixes on IPv4 Point-to-Point Links' and I'm interested in implementing it on a point-to-point uplink network that terminates on one end to a Catalyst 3750 routed FastEthernet port ("no switchport").I can e...
I ran across a document named "BGP Case Studies" earlier this week:http://www.cisco.com/warp/public/459/bgp-toc.htmlIt has a line that says: "The set clause for outbound route maps does not affect routes that reflect to iBGP peers"This means just ref...
I'm reaching the point where my 7206VXR w/ NPE-G1 is seeing sustained 60% - 70% cpu utilization from IPSec encryption / decryption. I'm running IOS 12.4(9)T. I was thinking about purchasing one or two VAM-2+ modules to offload the encryption, but I...
Well I finally found the right search on Google to get the answer to my question: +PBR +NHRPI came across this link:http://puck.nether.net/pipermail/cisco-nsp/2006-May/031088.htmlwhich led me to these Cisco Bugs:CSCef95982CSCef66719Both bugs describe...
Here's a simpler take on what I want that isn't working....Spoke 1 Serial 0: 3.3.3.3Spoke 1 Serial 1: 4.4.4.4 (default route)Spoke 2 Serial 0: 7.7.7.7Spoke 2 Serial 1: 8.8.8.8 (default route)It works if I configure:(Spoke 1)ip route 7.7.7.7 255.255.2...
Thanks for the links and the info. Unfortunately our setup falls just beyond any of the standard scenarios described, and the behavior is understandable, but the fix I'm trying to implement (policy-based routing) isn't behaving as I expect.The probl...
Thanks to all responders on this. This last post describing the link-local actually made everything click for me.I've been mostly concerned about how broadcast traffic on the point-to-point link would work (ARP, L3 broadcasts, etc) but was stuck thi...
Thanks for the info. I'm sure this is what I'm looking for, but my router isn't responding to anything under the .171 OID. Doing an snmpwalk against 1.3.6.1.4.1.9.9, it jumps from 1.3.6.1.4.1.9.9.168 to 1.3.6.1.4.1.9.9.176. I'm running 12.4(9)T Ad...
