Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am getting ready to deploy several Cisco 4506s which are running Sup IVs. These switches will connect back to a Cisco 6509. I want to use layer 3 to connect these 4506s in the wiring closets back to the 6509. The problem is my environment runs IP a...
I’m using LEAP with a Cisco ACS and Aironet 350 access points. I have configured the ACS to change the WEP keys every 30 minutes. I’m getting the following message periodically on the access point.“No EAP-Authentication response for Station”.The clie...
I have been told the PIX isn’t able to do stateful inspection on packets before passing them to the internal interface when terminating an IPSec VPN. I have also heard the packets are decrypted first then statefully inspected before being handed to t...
I have just set up 3 Aironet 350 APs, all signals overlap and all APs have the same SSID.All APs are also set up on differant channels (1,6,and 11). I'm also using LEAP. I'm using Compaq iPAQs with the Cisco Aironet 350 PCMCIA cards as the clients. E...
I noticed the interface in question is forced to 100Mb/s full duplex. Are the devices you have tried to connect to this interface forced to 100Mb/s full duplex as well? A duplex mismatch would also explain the collisions this port is seeing.
