Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We're trying to reverse telnet from an AS2511 async ports to a Larscom Mega-T inverse mux DB9M SUP1 port. The AS2511 RJ45 uses pin 3/4 TXD&RXD and Larscom uses pin 2/3 TX/RX. All control LED up but we can't reverse telnet. Has anyone implemented suc...
We want to connect a Cisco 2511 with 16 Async ports to a Larscom Mega-T inverse MUX to capture or to monitor trap message if and when 4 of our DS1 circuits goes down.I need cable requirement or pin-out between Cisco 2511 Async rj45 ports via Mega-T s...
Hi,Actully it's an RJ45 from the AS2511 Async ports to the Larscom Mega-T DB9M SUPV PORT1&2. The ideal is connect the two gather to capture trap messages and alarms from the Mega-T DS1 circuits. We don't have any cable spac's from Cisco AS2511 RJ45...
