06-02-2004 07:24 AM - edited 03-13-2019 05:07 AM
We want to connect a Cisco 2511 with 16 Async ports to a Larscom Mega-T inverse MUX to capture or to monitor trap message if and when 4 of our DS1 circuits goes down.
I need cable requirement or pin-out between Cisco 2511 Async rj45 ports via Mega-T supv port1 and supv port2 DB9M.
And please include any sample configure.
Thanks,
Allen
06-08-2004 09:18 AM
The cross over cable pinout for back to back connection for Larscom Mega-T using Cisco CSU/DSU is as follows:
From RJ 48C PinTo RJ-48C Pin
1
4
2
5
4
1
5
2
06-08-2004 09:43 AM
Hi,
Actully it's an RJ45 from the AS2511 Async ports to the Larscom Mega-T DB9M SUPV PORT1&2. The ideal is connect the two gather to capture trap messages and alarms from the Mega-T DS1 circuits. We don't have any cable spac's from Cisco AS2511 RJ45-to-LARSCOM DB9. I'm curious if anyone else out there is implementing this type of solution to capture snmp and or trap message via reverse telnet?
Thanks,
Allen
Network Engineer III
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide