Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Im having issues with changing the cost of a learned ospf route. the route map pics up the route but the set metric command isnt working. Am I missing something? ip prefix-list DEFAULT_ROUTE seq 5 permit 0.0.0.0/0route-map test permit 10match ip addr...
Hi guys Ive been noticing that my DMVPN setup has been having intermittent issues with sites that are in transport mode.Every now and then I would have a site go down and would have to clear the isakmp sa session for it to come back up again. I have...
Hi guys Im having an issue whereby my DMVPN has peered with my spokes and OSPF neighbors have formed adjacency but for some reason the routes are not showing on either end. When I look at the database I can see them but not in the respective routing ...
We currently have our ISE administrators using AD external identity sources to log into the servers however weve noticed that even with the super user setup we are unable to have full control. Is there something that can be done to allow AD admins to...
Last night we had a power outage and our switch booted up with power from only one PSU. Now the switch has a steady amber status light and I see the below message.
system minor alarm on power-supply 1 power-output-mode (raised 16:18:36 ago)
system ...
So guys Ive decided to let both default routes have the same cost, making both default routes present in my downstream routers. I only hope that this will have the desired effect of load sharing internet traffic between the two firewalls.Thanks every...
The default routes are e2. The router is ospf neighbors with both firewalls in the same broadcast segment. This router is a secondary dmvpn hub. We also want it to pass traffic via our secondary internet hence the reason to alter the cost.
we have 2 fortigate firewalls with static routes being redistributed into OSPF. One firewall redistributes with a higher cost than the other. What I would like to do is to change the cost of one of those default routes for one of my downstream router...
