I am having as5300.On one fine day it has gone in a RTR1(boot)> prompt after power on reset.It is not going to normal mode.I erased the entire flash: and tried to upload the compatible IOS image.Through tftp entire image is getting transferred but af...
The IOS is Version 12.0(5)T1Router5300#Sh contro e1 0 E1 0 is down. Applique type is Channelized E1 - balanced Cablelength is Unknown Far End Block Errors Detected Receiver has loss of signal. Version info of Slot 0: HW: 1, Firmware: 4, PLD Rev...
I am having as5300.On one fine day it has gone in a RTR1(boot)> prompt after power on reset.It is not going to normal mode.I erased the entire flash: and tried to upload the compatible IOS image.Through tftp entire image is getting transferred but af...
I am having as5300.In the flash: of it there are number of invalid checksum files.How to remove these files without erasing the entire flash.Following is text of show flash: System flash directory: File Length Name/status 1 373849 mica-modem-portware...
I am having as5300.In the flash: of it there are number of invalid checksum file how to remove these files without erasing the entire flash.Following is text of show flash:System flash directory:File Length Name/status 1 373849 mica-modem-por...
Thanks JackI am using tftp for transfer.Whatever I am trying to transfer ie modem PW or IOS the entire file is getting transfered with correct size but after verifying for checksum it is giving invalid checksum error.Following is the error it is show...
Thanks GPTried changing the clock source of E1 0 to secondary and that of E1 3(Configured as PRI) clock source as primary.After that the E1 0 is up but it is showing as cablelength is Unknown.Following is outputE1 0 is up. Applique type is Channeliz...
Thanks for replyThe same provieder output when given to another as5300 the E1 int on that immediately come up.Framing type CRC4 or NO-CRC4 does't make any difference.When local loopback is given the int is showing locally looped but is still showing ...
Dear b.hsuWhen I am trying with /m it is not recognising the file at all as its a invalid checksum file.routerI#delete m/Delete filename [m/]? c5300-i-mz.120-7.TDelete flash:c5300-i-mz.120-7.T? [confirm]%Error deleting flash:c5300-i-mz.120-7.T (No su...