Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently upgraded my PIX 515 from 6.35 to 7.12. Before the upgrade I was able to remote desktop into my servers from home. After the upgrade when I try to connect it appears to be trying to connect. However, I get a message stating the network is b...
My 2924M went out in one of my dorms. Cisco has a new deal in which I can opt to get a 2950 for free instead of a 2924. Since the 2924 is EOL I took the 2950. The 2924M was connected to my 6009 via mulit-mode fiber (62.5) with one hop in between. The...
I have a 2924M in one of my dorms that I cannot get an IP address on. The software version is 12.0(5)WC13. The main interface back to the 6009 shows up. This switch is connected back to a 6009 via multi-mode fiber. I can ping this switch, but no IP. ...
Is there are way to write some type of script to make multiple changes on several switches? I use telnet to get into the switches. Any help would be appreciated. Thanks, Laurie Coles
I'm ghosting from one PC to another. The PCS are on both on the same vlan. Yesterday I was doing the same thing and it took about 15 minutes. Today the ghosting application is stating it will take about 1 hour. There is nothing different today than y...
I was told 4Db not Dbm. So if it is 4Db, then that is too high and it needs to be lowered. That can possibly be done by cleaning the fiber ends. Since I'm fairly new at this could you explain how to loop my connection? I have already switched the Tx ...
This switch is in vlan170. I did a show vlan and it is posted below. It appears normal to me. Yes, the switch is a trunked switch. Laurie VLAN Name Status Ports---- -------------------------------- --------- -----------...
The switches are not in enable mode and my devices are all connected to a 6009 via fiber. I don't think will work. I wish I could use some type of batch program. I'll check out the tclsh. Any other suggestions would be appreciated. Thanks, Laurie
Thank you for the suggestion. After working on this all day it was discovered that a switch on the ghosting executable file needed to be turned on where it would use the computer's bios. We used to use this switch on computers a long while back. Now ...
I was unable to find the answer to my question on the cisco web site. For me at least, their web site reminds me of the old IBM manuals. That is why I was asking the question. Why would you use authenciation on Cisco Clean? To answer your question, I...
