Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I am kind of newbie to the voice world and I needed some help setting up my dial-peers:I have a call manager managing all my voice calls and I have also a SIP faxing software for sending faxes out, what I needed is when I am sending out faxes...
Hi all, I have what I think is a simple question.I am exploring the IOS FAX capabilities and I needed the following:I have a software that enables me to send faxes through SIP, on the other end I need a gateway that will receive this SIP call and the...
Hi all, is it possible to configure or get some kind of configuration that would run either Hunt lists or members of line groups in a loop?I have a line group with several members what I needed was if after one pass no one picks up the incoming call,...
Hi all,I need to configure an inbound nat rule on a PIX firewall so that a network that comes in through a VPN on the outside interface translates to a dmz interface (PAT).I have the configuration in place to setup all the translation rules without t...
Thanks, it was not me that configured the voice gateway and I am trying to understand it's configuration so I can then make the changes I need.Frim what I already gathered it seems to me that dial peers 1 and 2 are being used both for inbound and out...
Hi, thanks for you reply.Is there any document you can refer to me regarding the proccess for choosing a dial-peer?Also I've tested configuration putting in a specific incoming called-number for the fax dial peer (just for testing purposes) and it wo...
Hi Rob, found the solution to solve this!!!I have configured my hunt pilot to call itself ("Hunt forward settings") on both forward no answer and forward busy.I've tested this and it works, it put the call into a loop.Thanks for all the assistance
Hi again Rob, yes the workaround will work, my only issue is that it won't garantee 100% that a call will be picked up.I will use that workaround and at the end setup a voice mailbox for the call that fail to be picked up.Thanks for the help.RegardsR...
