Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We're trying to install AnyConnect 3.0.2052 on a Windows 7 32 bit machine, but even with the user as an Admin on the box we're getting this error message when the install wizard attempts to install services: Service 'Cisco AnyConnect Secure Mobili...
We have support staff who work from home and connect to our business network using the Cisco AnyConnect SSL client ver 3.0.2052. These support staffers use Windows Remote Assistance to remotely connect to users to assist with troubleshooting issues. ...
We have 5580s and 5550s, all on 8.4(2) and configured to allow AnyConnect SSL clients to connect using DTLS. We have enough users complaining of frequent dropped VPN connections, and see enough disconnections in our syslogs, to be concerned. All of...
We're running VPN on ASA 5580s, v 8.4(2), and our clients are all AnyConnect SSL clients, v 3.0.2052. We're getting reported issues of frequent disconnections when Windows users are on a WLAN - both home and in public hotspots. When at home, users ...
We're going to use the ASA for VPN services for users out on the internet who want to connect to our network remotely. We throttle user bandwidth today with our Nortel Contivity, and I'd like to do the same for all users connected via the ASA. Can ...
Thanks so much, Sooraj. I was really hoping for some specific OIDs, as I don't have a lot of time to search the MIB documentation to find what I need. I'd specifically like OIDs that other folks have found useful, in case they've had good luck moni...
Just realized this had a simple solution... from the local server, I launched Ethereal and did a trace that filters on udp port # X, X being the port # I configured on my routers for the destination of the flows.
I ran some debugs on the AP which did not show much. A wireshark trace off a problem laptop's wireless NIC shows that the user gets authenticated successfully, sends out 4 DHCP requests, then gives up and goes with the local 169.254.x.y address. Me...
