Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a new FPR2130 with the 8x 10G module FPR-NM-8X10G. Currently connected using SFP-H25GB-CU3M DAC cables up to a Nexus 93180. For the link to come up, I had to force the N9K side to speed 10000, fec auto. This has been working OK. However out of...
Agreed. I also had similar errors when upgrading and it getting stuck on certain .py scripts. TAC can guide you through some back end DB commands. I assume you have rebooted FMC?
Hi Tracy, On a 9300 you can only change the MTU system wide:Device(config)# system mtu xxxx Or on a routed interface only.Device(config-if)# ip mtu xxxx https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-6/configurati...
Hi Tracy, i'm no expert but have seen my fair share of riverbeds. I have only ever used 1500 MTU on the riverbeds I deploy. Figured having more than that might cause additional headaches when i'm setting a tunnel interface to 1470 anyway (ipsec overh...
Would it be redundant? Most likely yes, but it only achieves redundancy, not so much throughput. Depending on how the server is setup it may only use one link at a time. and if one of your L2 switches fail, it would re converge to the other.Spanning ...
