roturner

Hello, if you register the MCU as SCCP and a conference resource then only SCCP points could initiat...

HelloMy problem was with a 3511 which does not have an EMP and to understand the speeds of a 4 way c...

Hello I think you rather mean how do you integrate the Polycom VSX7000 with the Cisco MCU. Well firs...

Hello DevangThe routers at your sites will most probably work now as I am assuming you are set for Q...

Hello folks, I am having a problem understanding how to create a service on a IP/VC 3511 running 4.2...

Hello there, the command you are seeking is modifyTargetDevice and note it is case sensitive. From h...

Hi RickThanks for your input. I believe it is a bug in 12.2(40)SE as if you have the command in star...

My customer has many 3560 switches configured with TACACS and several have no servers under the aaa ...

Hello, you are right in what you say and if you upgrade it will cure the issue. I suggest you upgrad...

You can use any endpoint that supports either H323 or SCCP. If you wanted to work with CCM then you ...

Hi Duanne You are making good progress and yes for V.120 you need what you have said plus new vty li...

Hi DuanneHere is a bit of config that should work for you if you modify to your needs.virtual-profil...

If you have ethernet then it must be full duplex. The WAN link needs LLQ and you should check it is ...

Hi DuanneYou need to configure the d-channel for dialer pools and create dialer interfaces for the f...

Hi WilliamAre you doing thisconf tenable password xxxxcntrl zIf so do you have the enable secret whi...