Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having a tough time getting my hands on a lab 9300Can someone please post a copy of the Configuration of a Cat 9300 before and after running auto QoS.Ideally I would live to see what happens after you do a "macro apply cisco-phone $access_vlan 2...
The Cisco documentation on creating the Stackwise Virtual link between Cisco Cat 9ks says that a combination of different Interface speeds is not supported. I read that along the same lines as creating a port-channel requires the interfaces to all be...
This document Quality of Service (QoS) Configuration Guide, Cisco IOS XE Everest 16.5.1a (Catalyst 9300 Switches) - Configuring Auto-QoS [Support] - CiscoShows the output of Show commands displaying the qos in action but it doesn't show the actual co...
The command you need is no mac-address-table learning vlan vlan-id This will turn an individual VLAN into a Hub.If your span is of a trunk which for IDS mine is then you need to create each VLAN on your switch you are connecting to the IDS and disab...
If I am assessing your issue correctly you are running into the problem that a local span port can only have one Destination and you need the traffic mirrored to multiple ports at once. So you are hoping to make a switch into a Hub to achieve this.If...
