Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hiya,I have an issue with a PIX 515E using radius authentication. What i am trying to achieve is to authenticate all users on the inside network when accessing any network on the outside. This firewall is not connected to the internet and is only bei...
Hi,I have 2 x cat4000 with sup 3 engines. The switches are interconnected via Gigabit ISL trunklinks. The switches have 2 vlans configured on each, vlan2 and 3.Switch one is the active router for vlan 2 and switch2 is active for vlan 3. However, whe...
i have two cat 4000 with sup 3 engines. Both of my servers are configured as VTP servers so that VLANS can be created on either. However,it seems that when i create a vlan on one switch it is not being propagated to the other switch.I have tried re-b...
I have a vpn3000 concentrator and use vpn client 3.5.2a. When the users connect via remote access everything works fine, full conectivity everywhere. However when i create a tunnel from the internal office while connected to the local LAN, I can crea...
Hi a_vazquezI am having a similar problem. My setup is with Cisco AP 1200 (2.4 + 5.0GHZ) and a FUNK SBR radius server. The setup is in a lab scenario as we are at the design stage.The client (HP notebook with W400 wireless card) is configured for LEA...
Hi Guys,I am having a similar problem to you, however i can get authentciated via LEAP, but dont seem to get an IP adderss from the radius server.My setup is very simple as i am at the design stage. We have a Cisco AP 1200 (2.4 and 5.0 GHZ) and we ar...
