Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyoneI have a situation in a lab where I'm running a couple ASAs (ASAv version 9.14(1)). On one of them I'm trying to configure a static route using tracking, when I do that it doesn't show in the routing table.asa# sh run routeroute point2poin...
Hi @Okami11 It should be possible if you want only the PCs to communicate with each other just remember if you're not doing static IPs, you'll have to create the DHCP pool on the switch so that it can assign IPs to new PCs, if not just make sure yo...
Hi @systems100 I'm not aware of a specific command that will show you that but you could try a debug (debug crypto isakmp), first enable the debug then trigger the tunnel and you should be able to see the mode that's being used in the messages. HTH
@mani1910 You can try "sh run | i my-internal-ip network" to find out where the object is being used, that would show you the ACLs then with that just find the order and as indicated by @Rob Ingram just add an ACE. HTH
Hi @MartinStuka It seems like the switch did restart after 497 days, anyway I was reading that other Cisco products (MDS, WLCs, etc) show the same behavior and Cisco in those cases recommends to restart the devices before the 497 days or upgrade the ...
Hi Take a look at these 2 links https://quickview.cloudapps.cisco.com/quickview/bug/CSCvv57812 https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvv57812 Sound like that's the problem you're having.HTH
