Hi All,I am upgrading the Cisco IOS on Catalyst 6509E for the first time.I have read the procedure but still am confused.Would like to clarify my doubts?1. I can see the IOS image in both the sup-bootflash & sup-bootdisk[ 12.2(18)SXF4 ]2. When I perf...
Hi All,Can I bundle Fiber and copper ports into the same etherchannel in Catalyst 6500 series switches?I basically want to create redundancy,ie when fiber goes down,traffic still goes thru copperAll ideas are appreciated.Thanks
Hi All,I am trying to connect 2960 switches to the extreme Alpine switches.As per the diagram below,STP is not running in the alpines.I am not very sure whether STP should be enabled in this scenario to avoid any loops.All suggestions are appreciated...
Hi All,Can we use the same VLAN ID's on two different subinterfaces to setup a trunk link between Cat6500 & Cisco7513.Example:int fa 3/1/0.28encap dot1q 28int fa 4/1/0.29encap dot1q 28If not are there any other ways to setup the trunk to carry the tr...
Hi All,Is there any command to power off the router from the command line.(Or)the only possible way is to manually switch off the power??Thanks in Advance,
Thanks Jack for your quick and prompt response.One of my colleague has tested this in a lab setup,but not on a production network.Anyway I will let you know the result.
Hi Aaron,Thanks for your inputs.Sorry for the bad picture.Yea it exactly looks like a square,but in the Alpines STP is disabled.So I am a bit concerned whether to enable to it in 2960's.Any comments on this?Thanks
Thanks Jack for your quick reply..But can both the trunks carry the traffic of the same Vlans.How will this work? Sorry that am not very sure about this.Also I will be using two fastethernet links to create the trunk in cisco 7513 to cat6500.I am not...
