Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have been running 12.1(11)EA1a for a little while and I have notice thatmemory usage is slowly crawling up on the switches. I was wondering if any one else has notice this as well? Also since the IOS takes up so much memory on the switch to star...
This morning one of our 2950 drop offline. When I access it through the console the following error kept showing up SCHAN ERROR INTR: unit=1 SRC=6 DST=5 OPCODE=20 ERRCODE=5. I reloaded the switch and it is working well but I was just curious if...
I am wondering if any one has seen this problem before. We have 2950s that users are reporting of being droped. When investigationing they are still connected to the switch and they are in the the right vlan. But for some reason there mac address ...
I have about 100 2950G-48-EI that I would like to manage with RME 3.4 butit does not recognize them as switches but as generic snmp devices. Does any one know if they are being supported in RME 3.4 yet or if there is a patch or anything that will l...
Well I figure out what is causing this behavior. If you run the client from the CLI you can see the cvpnd process dies after it connects with the concentrator.
Yeah I am having the same problem with my Ibook which is a single G3 processor. If anyone has any suggestions on a possible fix or to trouble shoot the problem, I would love to hear them.
I had a similar problem in September. The problem was being caused by the mac address of a station being removed from the mac address table of the switch. To correct the issue grab the latest IOS.
