Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, we have a stack of switches (L3) when connected the internal LAN and DMZ, two ASA5510 in Active/Standby mode and a 2811 router.We want to put the WAE512 in the inside side of Firewalls managing the traffic of interlan LAN and DMZ, because as we f...
When the router starts it provide this message: "Bad RAM at location 0x00002D58: wrote 0x00002D58, read 0x0000AD5".Does this message means that the RAM must be replaced? How can we solve this problem??Thanks in advance.
we have three WLAN plants distributed in three sites with a total of 80 x 1000 series Access Points and 6 x 1231G AP (converted to LWAPP) and three WLC . Could anyone tell me if these APs may be managed via SNMP?? may they be configured to send traps...
We have a C2801 gateway with SRST and several IP phones behind. From last week people aren't able to make incoming and outgoing calls from and to PSTN. The ISDN LAyer 2 is down. It doesn't get to be up.This the output of the debug isdn q921:Dec 20 17...
Hi. We have a similar diagram.We have a stack of switches when connected the internal LAN and DMZ, two ASA5510 in Active/Standby mode and a 2811 router. We want to put the WAE512 in the inside side of Firewalls managing the traffic of interlan LAN an...
Hi all,we have a problem with this configuration.When we have a PC connected to an IP phone an this is connected to a Catalyst 3500XL the phone is registered and runs correctly, but the PC doesn't have connectivity. Anyone knows wha's happening and ...
