Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a lot of home users using soft phones and some have poor call quality. Is it possible to configure QoS on the ASA so that voice traffic is preffered on the user's anyconnect tunnels/sessions? I understand that wont fix the problem if there ...
Can someone tell me where I can find the date that anyconnect client 4.5 went end of support and also the date client version 4.8 is projected to go end of support? My company is currently running 4.5 on all endpoints and I need to make a decision o...
I can't seem to get a /32 route advertised from one of our site routers. Tried using the "mask" statement but the route doesnt show on the advertised routes. The /32 address I want to advertise is part of a /24 already being advertised which is als...
Is there a documented path to get from 8.2.5 to verion 9.X? Is the software even anailble for the documented path? I cant see anything accept 9.X on the support downloads.
I have 6 Cat 9300's getting installed in one switch stack. Each switch comes with it's own power supply but I was also given 2 extra power supplies (8 total). The desired goal is to be able to have zero down time if a power supply in any of the 6 s...
No I only have a broader /24 in the routing table which is a connected route because of a sub interface configured on router. I tried adding a static route ip route 192.168.100.10 255.255.255.255 192.168.100.10 but that didnt do it. Im kinda at a l...
Rahul would this exact same configuration work for many to many NAT also? My peer has a /22 prefix & on my side I have a /24 prefix. If I want to NAT the traffic & to be able to initiate from either side would I still use static and only need to sp...
By bi-directional do you mean that both my side and the peer side can start a new TCP connection or after my side starts a TCP connection the response traffic automatically gets natted back? I am not sure what device they are using. I have a techni...
