Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a pix 515 with an 4port FE card. I want to have two interfaces on my outside network ,Outside and Outside2. I want to terminate Remote Client VPNS on outside2 and Site site VPNS on Outside. When I try and add an IP address on the same net a...
Having problems getting routes to my internal network through my 506 pix. If I add the route on the pptp client pc then I can connect to services within my internal network. WIth the same clients I can connect to my corp office through a 515pix and...
Is it possible to have a site to site (PIX to PIX) IPSec VPN while having the PIX at one of these sites listen for PPTP remote access VPNs? Every time I apply my crypto map to the outside interface my PPTP clients stop getting routed to the inside ne...
I have a 2650 Cisco router that I have setup. From the internet or any remote site I can ping and telnet to the router (both interfaces Serial and Fastethernet). The problem is that my Firewall nor my external unprotected hub can communicate with t...
My internal network is directly connected to the pix and have no problems talking to it. It is my remote access VPN clients that have the routing issue. Once I add a static route to the Remote Access PPTP client then they are able to get connected ...
