Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Anyone know where to find which MIBs/OIDs are supported by the 4232 L3 module for Cat4000s? I've had no luck finding this information -- I can find MIBs for the Cat4000 SUP, but not the L3 module. Specifically, I'm trying to get CPU usage informati...
I'm researching various VPN endpoint solutions for our HQ site, and am hoping I can get some recommendations from those who have experience with this stuff. Essentially, we're in need of a device to terminate customer VPN tunnels at HQ (site-to-site...
Is there any information available about what the performance impact is of using port security on various switch models? I've never seen anything on Cisco's site about this, but I figure that has to be some type of performance impact (especially on ...
(Accidentally posted this to the VPN Network Management forum earlier today.)I'm in the process of deploying an SNMP infrastructure for our network using OpenNMS, and am wondering if I should use either traps or thresholds (or both?) to detect Cisco ...
I'm in the process of deploying an SNMP infrastructure for our network using OpenNMS, and am wondering if I should use either traps or thresholds (or both?) to detect Cisco events such as high router/switch temperature, high CPU usage, etc. I've alw...
I would assume you're either out of memory or that the remaining memory is so fragmented that it's essentially unusable. Is this router receiving one or more full BGP tables from peers?
I'm under the impression that you can use the same HSRP group on different interfaces and use a different virtual IP for each. These virtual IP's will use the same MAC address, but this generally isn't an issue.
I don't think you'll need to do anything with tags. I'm assuming you're trying to load share between the "other backbone routers" and the collection routers, and that each site has a single FR PVC to each of the collection routers. If so, redistrib...
We'll probably need some more information on what you're trying to do, how the two networks connect, etc. Standard routing will work regardless of whether or not the traffic is unidirectional. If your concern is that only the DVB traffic flow over ...
