Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
MY team is doing migration at remote site. They have similar two C6509 connected back via fiber.Before migration below is the command in Core 1;!interface GigabitEthernet8/1description to-Core2-L3PortChannel1-link1 no ip address mls qos trust dscp ca...
Hi Sir,My customer have few C7609s running as P/PE. Each C7609 are running with two sup 720BXL. One of the C7609 Active sup (in slot 5) suddenly become Unknown and the Standby sup (in slot 6) become Active. What is the main cause of this to happen?My...
Hi Sir,Due to inconsistent result during my customer UAT TE link FRR. All the 3 PEs (C7609) link are connected in triangular (three different POPs). From PE-to-PE it's interconnected via DWDM devices. In this scenario, how can we know what type of me...
Hi Sir,My customer have few C7609s with SUP720 3BXL and running IOS image s72033-advipservicesk9_wan-mz.122-18.SXF6.bin within the MPLS network.What I experienced is that I can't configured the built-in GE port of the SUP720 for Strict Priority & Pri...
Sir,My customer have single PE connecting to services to HQ running eBGP and other branches running OSPF protocol. Please refer to network diagram attached - ToDiscussForum_NetworkDiagram_Ver1_10112006.ppt.On B1CE1 router when I do a sh ip route, I c...
Hey All !I felt this new features make our call more lifely. Thanks for Cisco WebEx. With this function the participant just need to raise their hand when they have any questions to clarify and show thumb-up when they have got the question or unders...
Thanks for your prompt reply.I did tried it personally in the lab and I got the following message;PTT351.T01.08.DC.ED6(config-subif)#enc dot1Q 998 Command rejected: VLAN 998 not availableBelow cmd the complete "sh run" that I get my remote engineer ...
Hi Harold,Let me introduce myself first, I'm Lim's mentor.Thanks for the clarification. This seems to be a very good advice.P/S: Also thanks to Network.King for the guidelines.Best Regards,Raymond Hew
Hi Ankur,It's confirmed that the boot path is correct and it was being running for few months already and only recently it happens.Yes, agreed with you that when there is a problem happened the standby will take over the active rule! and the active b...
Hi Swaroop,First of all I would like to thank you on information shared and agreed we can do on other GiG ports in 76K except the "SUP720 built-in GiG ports".In my case, below is what the message I got when I tried to do what you have suggested;!poli...
