Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have issues across two 4500 switches interconnected by pry and backup link.The Pry(prymary) link is a Lan eXtensionThe Backup link has additional swithces in between performing Q-in-Q(L2TP)on the two 4500 switches pry and Backup links interfaces ar...
Hi All,I have CiscoWorks Common Services 3.1.1 and enabled the Ping sweep on a subnet where i have at least 20 Cisco switches and one router. CiscoWorks only discovered two hosts(One router and a dell switch) with one unreachable(dell switch) I don't...
Hi,I am upgrading the Ciscoworks Common Services from 3.0.5 to latest which is 3.0.6I am now running into issues that will not allow the successful installation of 3.0.6Error:===============process. You must stop all processes listed below toproceed ...
I am configuring QoS on 7609 routers to match NBAR and VLAN in my class map. The doc says the version 122-33.SRA2 supports it. However i keep getting errors that "Match vlan is not supported for this interface" same thing #match protocol telnetMatch...
Hello to you all,Can someone direct me on how to create jobs to download/update the configs on the remote devices on a regular schedule ?Also, I will like to create inventory reports on network devices, what is the simplest way to do this ? (Does Cis...
I did some additional show commands when the two links are up. See the capture attached.What should i do to make Swicth A see Swicth B. I have access to switches A,B,C and D.
ftallet,When i shut the prymary link. and enable the interfaces 2/6 on switch A and B it works okay.If i do sho cdp nei on switch A via pry link, i see swithces A and B as neigbours directelyIf i do sho cdp nei on switch A via bkup link i only see th...
Mohamed,See attach configI use use spanning-tree cost and priority commands while looking for solutions-------- ------- | |SwitchA|-------Pry Gi1/6---------|SwitchB | ...
The SNMP is string correct and verified again by retyping it. I have attached the Discovery settings summary for your view. I can Ping, telnet to those devices which were not discovered by ping sweep from the same Ciscoworks box.When you say "Discov...
